[[
A belső üreg kialakítása V. - lekerekítés
]]
CAD Feladatok
Trace:
•
Creating the middle section
•
Selecting sketch plane
•
Re-scaling the sketch
•
Drawing a circle
•
Checking references
•
Creating curved form at the lower right corner
•
Creating the hollow part I.
•
Hole creation
•
Dimension of the circle
•
Creating the hollow part IV.
Backlinks
This is a list of pages that seem to link back to the current page.
Nothing was found.
proe/cr1/020_szelephaz/cr1_020_110_szelephaz.txt
· Last modified: 2011/02/15 08:38 by