[[Creating dimension tolerances]]
 
Trace: • Creating dimension tolerances

Creating dimension tolerances

Dimension Properties


Comment

Before setting the tolerance (Shaft h7) on the picture, you have to invite the tolerance table from: File > Prepare > Drawing Properties > Tolerance > Cahnge > Tol Tables > Retrive shaft_h.ttl.

First PagePrevious PageBack to overviewNext PageLast Page

en/creo/cr1/040_alkatresz_rajz/cr1_040_110_alkatresz_rajz.txt · Last modified: 2016/06/15 21:08 by
 
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki